Operation Manual

4. Select a GPX or VCF file from the list. A list of all trips,
trails and destinations within the GPX file are displayed.
5. Select the trips, trails and destinations to import.
6. Select the Import button on the right side of the screen.
7. Select OK when completed. The USB device can be
removed.
EXPORTING A RIDE PLANNER ROUTE
1. Connect a USB drive to the computer.The USB drive must
be formatted to FAT16 or FAT32 (commonly used by most
PCs).
2. Open Ride Planner (www.h-d.com > Owners > Ride
Planner).
3. Create a new route or select an existing route (H-D Great
Road, rider-submitted road or personally saved road).
a. See Figure 122. Add locations for major destinations,
such as the start point and end point.
b. Add waypoints for other minor stopping points or
desired roadways to be traveled.
4. Select GPS Sync.
5. Select Manual Mode.
6. Select Save As GPX File.
7. Add a unique name for the route, and select Export Stops
and Waypoints.
8. Save the GPX file to the USB drive. By default, Ride
Planner will name the file as "HDRoute.gpx". Rename the
file to a unique name as necessary.
9. Remove the USB drive and import the file into the radio.
See NAVIGATION, Importing a Route.
NOTES
• See Figure 123. Ride Planner exports each pair of loca-
tions as a separate trip (even though the entire Ride
Planner route is exported as a single GPX file). In the
example, the route from Location 1 to Location 2 (with the
intermediate waypoints) is exported as a trip. The route
from Location 2 to Location 3 is exported as a separate
trip.
• The Boom! Box navigation system does not differentiate
between locations and waypoints. All items are imported
as destinations. When plotting a route, remember that
each trip can only include a total of nine destinations.
• Ride Planner exports locations and waypoints into the
GPX file. It does not export the highlighted route. The
exact routing between destinations may be calculated
166 Navigation