Operation Manual

response is received, try other channels or find another way
to get help.
TRANSMITTING ON CB
Start transmitting: While on any screen, wait until other active
CB transmissions are finished and the channel is clear. Press
and hold the PTT switch to begin transmitting on the current
CB channel. Any sound picked up from the rider and passenger
microphones will be transmitted.While the PTT switch is held,
all other audio is muted, including any inbound CB messages
that may be coming in. The CB Active icon will be displayed
in the status bar during the transmission.
Stop transmitting: Release the PTT switch to stop transmit-
ting. The status bar will show the CB Idle icon. Audio will be
resumed, and any CB audio that breaks squelch will be
received.
om02044
Figure 83. CB Active
RECEIVING CB AUDIO
The radio will receive inbound CB audio while on any screen.
When an incoming CB signal breaks squelch, the CB audio
interrupts (or mixes) with the current audio source in the radio.
While CB audio is being received, the CB Active icon is dis-
played in the status bar.
If necessary, adjust the squelch level so noise does not break
squelch, but desired CB audio is still received.
CB audio is received through the speakers or the headsets,
depending on the audio routing settings. See SYSTEM SET-
Citizen Band (CB) Radio 111