Operation Manual

om01988
Figure 71. Incoming Call
RECEIVING A CALL: RADIO TURNED OFF
Phone calls can be received while the radio is turned off.When
a call is received, the radio displays the call information and
plays the ring tone. If the call is accepted, the phone features
operate normally.The radio turns off when the call ends.
ENDING A CALL
Selecting the End button:The call terminates.The caller can
then be added to the saved list by selecting the Save button.
Making a new call: Initiating a new call will terminate the cur-
rent call.
Accepting a new call: Accepting a new call will terminate the
current call.
ADJUSTING CALL VOLUME
During a call, use the volume hand control switch to adjust the
incoming call audio. The passenger can use the volume con-
trols on the Tour-Pak to adjust volume in the passenger
headset.
MUTING CALL AUDIO
Muting microphones:While in a call, select the Menu button.
Select the Mute/Unmute button until Mute is displayed. The
call screen displays a Mute icon in the lower right corner. Audio
from the rider and passenger microphones will not be sent over
the phone.
Unmuting microphones: Press the Mute/Unmute button until
Unmute is displayed. The Mute icon is removed and the
microphones resume normally.
Muting inbound audio: Use the volume hand control switch
to adjust incoming audio to minimum volume. The
POWER/MUTE button does not mute incoming phone audio.
ROUTING CALL AUDIO
Outbound call audio is always spoken into the rider and pas-
senger microphones. However, the inbound call audio can be
Phone 97