Getting Started

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 521028_23.08.2022
Spaceship PowerBar 40
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal rm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult your
local waste disposal facility.
EN
Using the product
1. Connect the device to the mains using the supplied power cord to put the
device into operation.
2. Use a suitable voltage supply cable to connect eect pedals or similar devices
which require 24V
supply voltage at a maximum of 2000mA to the out-
put1.
3. Use a suitable voltage supply cable to connect devices with high power
consumption (i.e. multi-eect devices) which require 9V
supply voltage at
a maximum of 3000mA to the output2.
4. Use suitable voltage supply cables to connect eect pedals or similar devices
which require 9V
supply voltage at a maximum of 250mA to the out-
puts34.
5. Use suitable voltage supply cables to connect eect pedals or similar devices
which require 9V
supply voltage at a maximum of 500mA to the
outputs57.
Danger of property damage by polarity reversal
Make sure that the polarity of the devices to be connected must be
the same as the polarity of the power supply outputs (
). To
power a device with polarity-reversed voltage may damage it!
6. Use suitable voltage supply cables to connect eect pedals or similar devices
which require 9V
,12V or 18V supply voltage at a maximum of
500 mA, 375 mA or 250 mA to the outputs8-9. Set the associated switch
above the output to the position of the required voltage. The maximum output
power of 31.5 W must not be exceeded.
7. Use suitable voltage supply cables to connect devices as smartphones or
tablets to the USB outputs.
8. Each operational output 1-9 is indicated by a green LED. If an output is switched
o due to overload, the LED turns o. Then disconnect the pedal in question
from the device. After approx. 2 seconds, the normal voltage supply is restored
here.
9. To switch o the device, disconnect the power cord from the mains.
Danger of property damage by overvoltage
Make sure that connected devices are actually suitable for the set
voltage. To power a device with overvoltage may damage it!
Technical specications
• Connections ( )
- Output 1 24V @ max. 2000mA
- Output 2 9V @ max. 3000 mA
- Outputs 3-4 9V @ max. 250 mA (individually insulated)
- Outputs 5-7 9V @ max. 500 mA (individually insulated)
- Outputs 8-9 switchable 9/12/18V @ max. 500/375/250mA
(individually insulated)
• USB output USB-C max. 18 W
USB-A max. 18 W
• Power output 31.5 W
• Current output 2625 mA
• Supply voltage 100 - 240 V ~ 50/60 Hz
• Dimensions (W×H×D) 450 mm×30 mm×50mm
• Weight 0.57kg
• Ambient conditions Temperature range 0 °C...40°C
Relative humidity 20 %...80 %
(non condensing)