Quick start guide

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 380059_24.11.2020
EN
Safety instructions
Intended use
This device is intended to be used to integrate multiple eects devices into the signal
path between instrument and amplier. Dierent congurations can be stored. Any
other use or use under other operating conditions is considered to be improper and
may result in personal injury or property damage. No liability will be assumed for dam-
ages resulting from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are
not within reach of babies and young children. Choking hazard! Ensure
that children do not detach any small parts from the product. They could
swallow the pieces and choke! Never let children unattended use electrical
devices.
Where to use the product
Never use the product
• in direct sunlight
• in conditions of extreme temperature or humidity
• in extremely dusty or dirty areas
• at locations where the unit can become wet
• near magnetic elds
For the transport and protective packaging, environmentally friendly materials have
been chosen that can be supplied to normal recycling. Ensure that plastic bags, packag-
ing, etc. are properly disposed of. Do not just dispose of these materials with your normal
household waste, but make sure that they are collected for recycling. Please follow the
notes and markings on the packaging.
This product is subject to the European Waste Electrical and Electronic Equipment
Directive (WEEE) in its currently valid version. Do not dispose of your old device with
your normal household waste. Dispose of this product through an approved waste
disposal rm or through your local waste facility. Comply with the rules and regula-
tions that apply in your country. If in doubt, consult your local waste disposal facility.
Quick Start Guide
This quick start guide contains important information on the safe operation of the
device. Read and follow the safety advices and instructions given. Retain the manual
for future reference. If you pass on the device please include this manual.
Features
• 10 minutes maximum recording time
• Unlimited overdubs
• 1/4" phone in and output
Controls and functions
Using the Looper
Recording / Overdubbing
• When the LED is o, press the foot switch once to activate the recording mode – the
LED will turn red.
• Press the foot switch once in recording mode to activate the playback mode – the LED
will turn green.
• Press the foot switch once in playback mode to activate the overdub mode – the LED
will turn red.
• Press the foot switch once in overdub mode to activate the playback mode – the LED
will turn green.
Deleting recordings
• In playback / overdub mode, keep the foot switch pressed for at least 2 seconds until
the LED blinks twice quickly. Then the last recording is deleted.
Technical specications
Input: 1/4" phone socket (impedance: 470kOhm)
Output: 1/4" phone socket (impedance: 100kOhm)
Power supply: 9V , centre negative ( )
Current draw: 94mA
Dimensions (W×H×D): 93 mm×45 mm×50mm
Weight: 150g
Restoring recordings
• To restore a deleted recording keep the foot switch again pressed for at least 2 sec-
onds until the LED blinks twice quickly. Then the last deleted recording is restored.
Starting, stopping deleting the loop
• In playback / overdub mode, press the foot switch twice quickly, then the LED blinks
green and playback / overdubbing are stopped.
• Press the foot switch while playback is stopped to let playback start again. The LED
lights green.
• In playback / overdubbing mode, quickly press the footswitch twice. On the second
press, hold the footswitch for 2 seconds to clear all recordings. The LED goes out.
1 Function switch to control the unit
2 LED for indicating the various functions
3 LEVEL control for adjusting the volume
4 Input socket for connecting the instrument
5 Output socket for connecting an amplier etc.
6 Voltage supply connector (9V,
)
Electromagnetic compatibility with other electrical equipment
Operating the device near radios or televisions may lead to radio interference. Then increase
the distance between the devices.
General handling
• To prevent damage, never use force when operating the switches and controls.
• Never immerse the appliance in water. Just wipe it with a clean dry cloth. Do not use liquid
cleaners such as benzene, thinners or ammable cleaning agents.
• Disconnect the voltage supply of the device from the power grid when it is not in use.
Keep foreign substances from the unit!
Keep the device away from containers with liquids. Should any liquid get into the unit, this
could lead to its destruction or re. Be sure not to let any metal objects into the unit.
Mini Looper