User manual
Table Of Contents
- Table of contents
- 1 Safety instructions
- 2 Scope of delivery
- 3 Assembly instructions
- 3.1 Painting the body and neck
- 3.2 Mounting the tuners
- 3.3 Mounting the neck of the guitar
- 3.4 Wiring the potentiometers, pickups and switch
- 3.5 Mounting the pickguard
- 3.6 Mounting the tailpiece and bridge
- 3.7 Mounting the potentiometer knobs and strap buttons
- 3.8 Strings, neck relief and the position of the strings
- 4 Protecting the environment
After adjusting string position, you can check the octaves of the guitar and readjust if
necessary. Tune all the strings to the correct pitch, gently touch the rst string right
above the twelfth fret and then pick the string. The harmonic you hear (at the 12th
fret) must be the same pitch as the picked string at the 12th fret). If the pitch of the
two notes diers, adjust the saddle for this string back (tone too high) or forth (tone
too low) on the bridge. Listen carefully and adjust gently until the two notes match.
Alternatively, you can also adjust the octaves with a tuner. In this case, the pitch of
the tone at the 12th fret must be the same as the unfretted string, but one octave
higher.
Assembly instructions
Electric Guitar Kit Single Cut
27