User manual
Table Of Contents
- Table of contents
- 1 Safety instructions
- 2 Scope of delivery
- 3 Assembly instructions
- 3.1 Painting the body and neck
- 3.2 Mounting the tuners
- 3.3 Mounting the neck of the guitar
- 3.4 Wiring the potentiometers, pickups and switch
- 3.5 Mounting the pickguard
- 3.6 Mounting the tailpiece and bridge
- 3.7 Mounting the potentiometer knobs and strap buttons
- 3.8 Strings, neck relief and the position of the strings
- 4 Protecting the environment
3.8 Strings, neck relief and the position of the strings
Thread the strings through the tailpiece, then over the bridge and saddle. Thread the
strings into the holes in the tuners, wind the end of each string around the tuner a
few times and then tighten each string nger-tight initially. Be sure the individual
strings are in the right position on the saddle.
Then tune each string in turn to the correct pitch. You can using a tuner or a pitch
pipe as a reference. Please note that the string tension will still drift and the guitar
will need to be retuned a few times before the strings are played in.
Stringing the guitar
Assembly instructions
electric guitar kit
24