User manual
Table Of Contents
- Table of contents
- 1 Safety instructions
- 2 Scope of delivery
- 3 Assembly instructions
- 3.1 Painting the body and neck
- 3.2 Mounting the tuners
- 3.3 Mounting the neck of the guitar
- 3.4 Wiring the potentiometers, pickups and switch
- 3.5 Mounting the pickguard
- 3.6 Mounting the tailpiece and bridge
- 3.7 Mounting the potentiometer knobs and strap buttons
- 3.8 Strings, neck relief and the position of the strings
- 4 Protecting the environment
Insert the output jack into the hole provided on the edge of the body. Guide the con‐
nector cable through the channel into the opening in the back for the electronic and
plug in both connectors.
Set the holder for the output jack in place and check whether the jack protrudes. It
should stick out over the holder enough that it can be screwed rmly in place with
the nut provided, but no further than necessary. Correct the position if necessary by
turning the counter nut inside appropriately.
Then screw the output jack holder onto the body.
Assembly instructions
electric guitar kit
16