User manual

2. Connect the RETURN interface of the amplier to the output socket (jack) [OUTPUT L] of

the unit.

3. Connect the SEND interface of the amplier to the input socket [RETURN L] of the unit.

4. Connect the input of the amplier to the output socket [SEND] of the unit.

5. Place the dynamic eects, Rah eects, EQ and Distortion/Overdrive eects before the

preamp.

6. Place the Noise Gate, Modulation, Delay and Reverb eects between the preamp and

the power amp.

7. Enable the FX LOOP module in the unit and disable the eect modules ‘AMP’ and ‘CAB’

for best results.

8. Set the FX LOOP module to serial mode. Move the pre-eects in front of the FX LOOP in

the eects chain. Move the post-eects after the FX LOOP in the eects chain.

Installation

multi eects unit