User manual

If the battery housing is damaged small amounts of the electrolyte may leak out. If this should

happen, seal the lithium battery in airtight packaging and wipe up the traces of electrolyte

using absorbent paper towels. You must wear protective rubber gloves when doing so. Clean

your hands and the aected surface thoroughly with cold water.

Never attempt to recharge non-rechargeable lithium batteries. When charging lithium bat‐

teries you must use a suitable charging device intended for the purpose.

Before disposing of the device remove the lithium batteries. Protect used lithium batteries

against potential short circuits, e.g. by covering the poles with adhesive tape.

Only use powder extinguishers or other suitable extinguishing agents to extinguish a burning

lithium battery.

4.2 Charging the unit

If the status LED of the main switch ashes blue when the unit is switched on, only a maximum

of 30 minutes of battery life remains.

Switch o the unit and connect the unit via the USB-C cable to the AC outlet. During charging,

the status LED of the main switch lights up red. Once charging is completed, the status LED

lights up green.

Starting up

DNAfx GiT Mobile

Multi Eects Unit