Installation Sheet

ManualsBrandsHardware Resources ManualsCabinet HardwareEMBM Series Bottom Mount Single Bin Trash Can Pull Out with Soft-Close Slides - 50 Quart Capacity

IMPORTANT:

Before you begin, make sure you familiarize yourself with all of

the parts and fully read the instructions.

CUSTOMER SERVICE:

Toll free customer help line available weekdays between

7:00 am and 6:00 pm Central Time at 800-463-0660.

TOOLS NECESSARY:

Screw gun or Phillips screwdriver and tape measure.

NOTE: If screw gun has a clutch, set to lowest setting so as not to

over tighten and/or strip screws.

PARTS IDENTIFICATION:

Installation Instructions for the WC-EMBM Series

STEP 1

Prepare Organizer for Install

• Remove wire basket from frame by pulling up.

Place the slide base inside cabinet, pulling forward

so slides are ush to interior face frame.

• Firmly secure using the four #8 x 5/8” pan head

screws provided.

STEP 2

Install Door Mounting Brackets

• Install the door mounting brackets to the door

with the 6 pieces of #8 x 5/8” at head wood screws

provided.

• Using a tape measure, determine the mounting

location for the top of the bracket from the cabinet

oor.

Double/Single Can 35 qt/50 qt Trash Systems

Scan to watch the installation video

https://delivr.com/2pjxh

A Mounting Base 1 pc

B Basket 1 pc

C Trash Can(s) 1 or 2 pcs

D Door Connection 2 pcs

E #8x5/8 Pan Head Wood Screw 4 pcs

F #8x5/8 Flat Head Wood Screw 6 pcs

G M5x16 Machine Screw 4 pcs

H M5x20 Machine Screw 2 pcs

I M5x14 Flat Head Machine Screw 4 pcs

4 pcs #8x5/8

Pan Head

Wood Screws

Remove the basket

wire from the 4

black plastic clips

13-3/4” to

top screw

3-3/4”

8-1/4”

Cabinet Floor

Double = 12”

Single = 9”

Summary of content (2 pages)

PAGE 1
Installation Instructions for the WC-EMBM Series Double/Single Can 35 qt/50 qt Trash Systems STEP 1 Prepare Organizer for Install STEP 2 Install Door Mounting Brackets • Remove wire basket from frame by pulling up. Place the slide base inside cabinet, pulling forward so slides are flush to interior face frame. • Firmly secure using the four #8 x 5/8” pan head screws provided. • Install the door mounting brackets to the door with the 6 pieces of #8 x 5/8” flat head wood screws provided.
PAGE 2
STEP 3 Attach Door Bracket to Pullout STEP 4 Adjust the Door STEP 5 Complete the Installation • Reattach the wire basket to the slide frame by pushing it into the plastic clips until it snaps tight. Insert the trash cans into the wire basket. • Cycle the organizer to ensure the soft-close slides are operating correctly. • Use the provided M5x16 machine screws to attach the door bracket to the pullout.