Installation Sheet

STEP 2 - Mark Rear Mounting Bracket STEP 3 - Install Rear Mounting Bracket
If the countertop is installed, pull the organizer partially open to gain access to the upper slide. Firmly
grasping the upper slide, tap it against the back of the cabinet. The rear bracket should make small
indentations in the back of the cabinet. Proceed to step 3. If countertop is not installed, pull the organizer
partially out to gain access to the rear bracket and install three (3) #8 x 5/8” Pan Head Wood Screws provided
in the slots. Proceed to step 4.
Remove the unit from the base again and then slide the rear mounting bracket o the slide.
Align the rear bracket prongs with the indentation marks on the rear of the cabinet and
secure with three (3) #8 x 5/8” Pan Head Wood Screws in the slots as shown. Re-install the unit
onto the slides, making sure as you push it in the cabinet, that the top slide is properly seated
into the rear mounting bracket. Operate the unit to make sure the undermount slides are
working properly.
STEP 4
Install Pullout Unit
STEP 5
Install Door
STEP 6
Door Mounting Adjustments
Pull the top front mounting bracket into position on the side of the face frame
(or cabinet) allowing for a 3/16” setback (shown left above). Firmly secure with
one (1) # x 5/8” Pan Head Wood Screw. Make sure the gap between the unit
and the side of the face frame is equal from top to bottom. Adjust accordingly
and then securely tighten the bracket set screw (shown right above). Operate
the unit and make adjustments as necessary for the slides to operate smoothly.
Loosen the door mounting set screws and slide bracket out to desired
position to attach to the door rail. Measure from the center of the slot
on the door mounting bracket to the estimated top of door. Mark
door with measurement for both top brackets. Install door with the
four (4) #8 x 5/8 Flat Head Phillips Wood Screws provided. (NOTE:
DETERMINE CORRECT SCREW LENGTH TO DOOR PANEL THICKNESS)
To adjust door up or down loosen door mounting
screws (A). To adjust left or right, loosen both
set screws (B) adjust and retighten. To adjust
tilt, loosen both set screws (B) and then turn tilt
screw (C) clockwise to desired distance and then
retighten set screws.
VBPO8-SC/17 v.1
3/16” Setback
Prongs to make
Indentations
Back of cabinet
Rear mounting bracket
Face frame
Door frame
Center of
mounting
bracket slot
to estimated
top of door
B
A
C
Tilt adjustment (up to + 1/4”)
Left/Right adjustment (+/- 7/8”)
Full extension (+2-1/2”)
Up/Down adjustment (+/- 1/4”)
Door mounting
set screws
Bracket set screw