Installation Sheet

Install slide release clips
Turn drawer box upside down and drill holes for undermount slide
release clips. Shown with optional multi-tool (HR-TOOL-300)
Install slide release clips with recommended # 6 x 5/8” pan head
screws.
Measure and mark for slide placement
3 mm
Setback
Drawer box
Shelf
Back of cabinet
Drawer front
Countertop
• Place slide in cabinet and verify the slide is at the correct height and is level.
• NOTE: Setback for overlay application is recommended 3 mm.
• Mark holes for predrilling. Remove slide while drilling holes to prevent wood chips from getting on the slide.
• Install slides with recommended #6 x 5/8” pan head screws.
* Not compatable with drawer bumpers
3 mm
Setback
Drawer box
Shelf
Back of cabinet
Drawer front
Countertop
Insert and lock drawer box
• Insert the drawer box until release clips lock in.
Verify drawer front is square
X
X
X
Side view
Top view
Top view