Installation Sheet

STEP 4
Install Pullout Unit
STEP 5
Install Door
STEP 6
Door Mounting Adjustments
Pull the top front mounting bracket into position on the side of the face frame (or
cabinet) allowing for a 3/16” setback (shown left above). Firmly secure with one (1)
# x 5/8” Pan Head Wood Screw (NOTE: You will need to install this screw with a
slight angle to your screw gun or screwdriver. A longer screw gun extension
or longer screw driver works best.) Make sure the gap between the unit and the
side of the face frame is equal from top to bottom. Adjust accordingly and then
securely tighten the bracket set screw (shown right above). Operate the unit and
make adjustments as necessary for the slides to operate smoothly.
Loosen the door mounting set screws and slide bracket out to desired
position to attach to the door rail. Measure from the center of the slot on
the door mounting bracket to the estimated top of door. Mark door with
measurement for both top brackets. Install door with the four (4) #8 x 5/8
Flat Head Phillips Wood Screws provided. (NOTE: DETERMINE CORRECT
SCREW LENGTH TO DOOR PANEL THICKNESS)
To adjust door up or down loosen door mounting
screws (A). To adjust left or right, loosen both set
screws (B) adjust and retighten. To adjust tilt, loosen
both set screws (B) and then turn tilt screw (C)
clockwise to desired distance and then retighten set
screws.
STEP 2 - Mark Rear Mounting Bracket STEP 3 - Install Rear Mounting Bracket
If the countertop is installed, pull the organizer partially open to gain access to the upper slide. Firmly grasping the
upper slide, tap it against the back of the cabinet. The rear bracket should make small indentations in the back of
the cabinet. Proceed to step 3. If countertop is not installed, pull the organizer partially out to gain access to the
rear bracket and install three (3) #8 x 5/8” Pan Head Wood Screws provided in the slots. Proceed to step 4.
Remove the unit from the base again and then slide the rear mounting bracket o the slide. Align
the rear bracket prongs with the indentation marks on the rear of the cabinet and secure with three
(3) #8 x 5/8” Pan Head Wood Screws in the slots as shown. Re-install the unit onto the slides, making
sure as you push it in the cabinet, that the top slide is properly seated into the rear mounting
bracket. Operate the unit to make sure the undermount slides are working properly.
UBPO/17 v.1
3/16” Setback
Prongs to make
Indentations
Back of cabinet
Rear mounting bracket
Face frame
Door frame
Center of
mounting
bracket slot
to estimated
top of door
B
A
C
Tilt adjustment (up to + 1/4”)
Left/Right adjustment (+/- 7/8”)
Full extension (+2-1/2”)
Up/Down adjustment (+/- 1/4”)
Door mounting
set screws
Bracket set screw