Installation Sheet

Install rubber washers:
Install rubber washers at all (8) eight
connecting points.
TTSPD-R
3-Tier Spice Pulldown
Included: Tools Needed:Minimum Opening:
Phillips
Screw Driver
Pencil
Tape Measure
(optional)
½” Wood
Screw (x4)
Support Arm (x2)
3-Tier Spice
Organizer (x1)
Mounting
Bracket (x2)
Rubber
Washer (x8)
1. Make sure the cabinet hinge will not interfere
with organizer when installed
4. Install mounting brackets with (4) four
1/2” wood screws provided.
5. Assemble the Spice Pulldown by placing the rear support arm on the
rear support peg on each side. Repeat for front support arm.
2. Layout and mark measurements for installation.
See diagram above.
3. Place rear support arm in the rear upper hole
of the mounting bracket and place the front
support arm in the front lower hole.
Installation Instructions
13-5/8”
min. opening
12”
9”
6-1/2”
2-1/2”