Installation Sheet

IMPORTANT:
Before you begin, make sure you familiarize yourself with all the
parts and fully read the instructions.
CUSTOMER SERVICE:
Toll free customer help line available weekdays between
7:00am and 6:00pm Central Time at 800-463-0660.
TOOLS NECESSARY:
Screw gun or Phillips screwdriver and tape measure. NOTE: If
screw gun has a clutch, set to lowest setting so as not to over
tighten and/or strip screws.
PARTS IDENTIFICATION:
A Trash Can Organizer 1 pcs
B Bottom Panel Liner 1 pcs
C Grey 35 or 50 Quart Trash Can 1 Single/2 Double
D #8 X 1/2” Pan Head Phillips Wood Screw 4 pcs
E #8 X 5/8” Flat Head Phillips Wood Screw 4 pcs
Storage with Style
Trash Can Systems
Scan to watch the installation video
https://delivr.com/2cjqh
STEP 1
Prepare Organizer for Install
Remove trash cans and the bottom insert panel. Remove
the organizer from the slides by pressing inward on the slide
release clip.
STEP 2
Slide Base Installation
Place the slide base inside the cabinet, pulling the front
cross member tight against the rear of the face frame. For
frameless cabinets, set the front cross member back 3/4”. For
inset door applications, slide the base back from the above
measurements plus the thickness of the door. Firmly secure
with four (4) # 8 X 1/2” Pan Head Phillips Wood screws provided
in the locations shown above.
Installation Instructions for
the SWS-MBM Series
Double/Single Can 35 qt/50 qt
Trash Systems
D
A
B
C
E
Press Inward
Bottom View
Four (4) # 8 X 1/2”
Pan Head Phillips
Wood screws