Installation Sheet

IMPORTANT:

Before you begin, make sure you familiarize yourself with all the parts and

fully read the instructions.

CUSTOMER SERVICE:

Toll-free customer help line available weekdays between 7:00am and

6:00pm Central Time at 800-463-0660.

TOOLS NECESSARY:

Screw gun or Phillips screwdriver and tape measure. NOTE: If screw gun

has a clutch, set to lowest setting so as not to over tighten and/or strip

screws.

PARTS IDENTIFICATION:

A Undermount Slide Base Assembly 1 pcs

B Organizer 1 pcs

C Fixed Shelf Liner 2 pcs

D Removeable Shelf Basket 1 pcs

E Removeable Shelf Liner 1 pcs

F Hooked L-Shape Support Bracket 4 pcs

G #8 X 5/8” Pan Head Phillips Wood Screw 8 pcs

H #8 X 5/8” Flat Head Phillips Wood Screw 4 pcs

Storage with Style Base

Pullout Systems

Scan to watch the installation video

https://delivr.com/2e3f7

STEP 1 - Prepare Organizer for Install

Remove the organizer from the slides by pressing inward on the slide

release clip.

Installation Instructions for

SWS-BPO & SWS-DBPO Series

Press Inward

Bottom View

STEP 2 - Slide Base Installation

Place the slide base inside the cabinet, pulling the front cross member

tight against the rear of the face frame. For frameless cabinets, set the

front cross member back 3/4”. For inset door applications, slide the base

back from the above measurements plus the thickness of the door. Firmly

secure with four (4) # 8 X 5/8” Pan Head Phillips Wood screws provided in

the locations shown above.

Four (4) # 8 X 5/8”

Pan Head Phillips

Wood screws

PAGE 1
Storage with Style Base Pullout Systems Installation Instructions for SWS-BPO & SWS-DBPO Series STEP 1 - Prepare Organizer for Install Bottom View Scan to watch the installation video https://delivr.com/2e3f7 IMPORTANT: Before you begin, make sure you familiarize yourself with all the parts and fully read the instructions. CUSTOMER SERVICE: Toll-free customer help line available weekdays between 7:00am and 6:00pm Central Time at 800-463-0660.
PAGE 2
STEP 3 - Mark Rear Mounting Bracket STEP 4 - Install Rear Mounting Bracket If the countertop is installed, pull the organizer partially open to gain access to the upper slide. Firmly grasping the upper slide, tap it against the back of the cabinet. The rear bracket should make small indentations in the back of the cabinet. Proceed to step 4.