Installation Sheet

STEP 2 - Pole Assembly STEP 3 - Shelf and Pole Assembly
(A) Adjust the nut on the height adjuster so that about 1/8” of the threads are showing below the
nut. (B) Insert the height adjuster into the end of the pole as shown, making sure that the guides
line up with the slots in the pole. (C & D) Then insert the height adjuster into the positive stop as
shown.
Slide the top of the pole through both shelves. Work the pole and shelf assembly into the cabinet.
(A) Place the positive stop in the center hole of the Lower Mounting Bracket and extend the twist-
n-lock pole until it is secure against the Top Mounting Bracket. Secure pole by twisting clockwise
to tighten. (B) Lift the top shelf to desired height and slide one pin through the hole in the pole as
shown. (C) Slide the shelf down the pole making sure the pin slips into the alignment slots as shown.
(D) Repeat with lower shelf making sure that the pin goes through the pole adjuster as shown.
PLSP 12/17 v.1
STEP 4 - Door Installation STEP 5 - Door Adjustment
NOTE: #8 X 1/2” LONG PAN HEAD WOOD SCREWS ARE PROVIDED FOR DOOR INSTALLATION. MAKE SURE THIS LENGTH IS CORRECT FOR
YOUR DOOR THICKNESS BEFORE USING THESE SCREWS. Turn the shelves 1/8 turn. Work the door into the cabinet and place into the
pie-cut corner. Place the template between the bottom of the door and the face frame and secure the door with one (1) screw in each shelf.
Carefully work the pie-cut around to be able to access the back of the other side of the door. Again, place template between door and face
frame and making sure the door is tight to the corner of the plastic pie cut, secure door with one (1) screw in each shelf.
Adjust door left and right by sliding the top or bottom
plate in the necessary direction. Adjust the height by
turning the adjustment wheel either up or down as
necessary.
A B
C D
A B
C D