Installation Sheet

STEP 2 - Install Hubs STEP 3 - Shelf Assembly
Press one (1) Shelf Hub into the bottom of the Plastic Shelf as shown creating the Shelf Assembly.
Repeat with other shelf.
From the top slide one (1) Shelf Assembly, the other Shelf Support and then the other Shelf Assembly
onto the Pole Assembly as shown. Slide bottom of Pole Assembly into the lower mounting support.
STEP 4 - Pole Extension STEP 5 - Shelf Adjustment
Holding onto the lower pole twist the upper pole counter clockwise to release. Extend pole
upwards until it rests rmly against the Top Mounting Support and tighten by turning the pole
clockwise.
Raise upper Shelf Assembly to desired height and tighten the Locking Set Screw. Raise lower Shelf
Assembly and tighten that Locking Set Screw.
PSLK2 8/16 v.2