Installation Sheet

Plastic Kidney Lazy Susans
Installation Instructions for the PLSK2xx Series
IMPORTANT:
Before you begin, make sure you familiarize yourself with all
the parts and fully read the instructions.
CUSTOMER SERVICE:
Toll free customer help line available weekdays between
7:00am and 6:00pm Central Time at 800-463-0660.
TOOLS NECESSARY:
Screw gun or Phillips screwdriver, and tape measure. NOTE: If
screw gun has a clutch, set to lowest setting so as not to over
tighten and/or strip screws.
STEP 1
Measure and Mount Supports
Top Mounting Support
Shelf Support
Plastic Shelf
Pole Assembly
1-9/32”
Locking Set Screw
Center Detent Marks
1-1/16”
Shelf Hub
Shelf Support used as
Lower Mounting Support
Shelf Hub
Top Mounting Support
Shelf Support
Plastic Shelf
Pole Assembly
1-9/32”
Locking Set Screw
Center Detent Marks
1-1/16”
Shelf Hub
Shelf Support used as
Lower Mounting Support
Shelf Hub
Mark layout for lower mounting support by placing a shelf into the cabinet upside down. Center the shelf on the bottom of the cabinet
making sure you have proper clearance from cabinet walls and door. Mark the mounting location by tracing inside the hole in the
middle of the shelf. Measure the center of bottom mounting location and transfer to the top of the cabinet. Align Top Mounting
Support with center detent marks and install with four (4) - #8 x 5/8 Pan Head Phillips Wood Screw. Place one (1) Shelf Support on lower
marks and secure with four (4) - #8 x 3/4 Flat Head Phillips Wood Screw to the bottom of the cabinet as shown (align set screw for proper
shelf orientation).
Top Mounting Support 1X
Pole Assembly 1X
Plastic Shelf 2X
Shelf Hub 2X
Shelf Support 2X
#8 x 5/8 Pan Head Phillips Wood Screw 4X
#8 x 3/4 Flat Head Phillips Wood Screw 4X
Top Mounting Support
Shelf Support
Plastic Shelf
Pole Assembly
1-9/32”
Locking Set Screw
Center Detent Marks
1-1/16”
Shelf Hub
Shelf Support used as
Lower Mounting Support
Shelf Hub