Installation Sheet

STEP 2 STEP 3
4-1/2” MIN
DRILL (2) - 3/32” PILOT HOLES
11-3/8”
3/8” MIN
TO INSURE PROPER INSTALLATION AND FUNCTION, USE A
LEVEL TO ESTABLISH THIS LINE.
1-1/2” COUNTERTOP
FIG. B
1-1/8” MIN
On both sides of the cabinet, mark down from
the top of the cabinet 4-1/2” and draw a 12”
long level line. On the line measure 3/8” and
11-3/4” from the back of the face frame (1-1/8”
from front of cabinet for frameless application)
and mark. Pre-drill 3/32” pilot holes 1/2” deep
on both sides at these four locations.
Install both mounting brackets as
shown above with the (24) - #10
x 3/4” Pan Head Phillips Wood
Screws provided. NOTE: To
insure proper operation of the
lift, 12 screws per mounting
bracket must be installed.
ML-1CH 1/17 v.1
STEP 4
FLOOR
36
”
4-1/2”
1-1/2”
11-3/8”
3/8”
22-1/2”
4-1/2”
4-1/4” clearance at lowest point
1-1/2”
FIG C
RECOMMEND SPRING POSITION
1= 10 - 15 LBS.
2 = 16 - 28 LBS.
3 = 29 - 42 LBS.
NOTE: MIXER LIFT SHIPS IN THE
SECOND POSITION
Tension
Adjustment Lever
24”
Following the recommend spring position for varying mixer weights shown above, adjust the spring by using a
10mm boxed in wrench to remove the set bolt while releasing the spring tension on the tension adjustment lever
by placing the box end of a 14 mm boxed in wrench over the end of the tension adjustment lever and pulling
toward the front of the cabinet. WARNING: SPRING IS UNDER HIGH TENSION! Do not release the tension
until the set bolt is in the desired location and rmly secured. Repeat with other side.
7-1/2”
20-1/2”
8-1/4”
3/4”
“W” MINUS 1-1/4”
FRONT OF SHELF MATERIAL
LAYOUT AND DRILL
(4) - 3/32” HOLES
BOTTOM VIEW OF SHELF
MEASURE DISTANCE
BETWEEN MOUNTING
PLATES AFTER
INSTALLED FOR “W”
1-5/8”
STEP 5
(Shelf material is not included) Shelf should be a minimum of 3/4” thick and no longer than 20-1/2” in length. Shelf
width is determined by measuring between the side mounting brackets “W” minus 1-1/4”. Mount shelf with at
least 8 suggested #8 x 1/2” wood screws (not provided) to mounting brackets as show in diagram on the left.
FLOOR
36”
4-1/2”
1-1/2”
11-3/8”
3/8”
22-1/2”
4-1/2”
4-1/4” clearance at lowest point
1-1/2”
FIG C
RECOMMEND SPRING POSITION
1= 10 - 15 LBS.
2 = 16 - 28 LBS.
3 = 29 - 42 LBS.
NOTE: MIXER LIFT SHIPS IN THE
SECOND POSITION
Tension
Adjustment Lever
24”