Installation Sheet
STEP 3 - Mark Rear Mounting Bracket
1. Peel o the cover of
the double sided tape.
2. Apply inward force
3. Pull organizer
slowly outward
First, peel o the cover of the double sided tape at the back of the rear
L-Bracket. Then applying an inward force at the front L-Bracket to ensure the
rear L-Bracket has a rm contact with the cabinet back panel. While holding
at the front L-Bracket, slowly pull the organizer halfway to gain access to the
release clip to release the organizer from the slide base.
STEP 4 - Install Rear Mounting Bracket
After remove the organizer from the slide base, the rear L-Bracket is rmly
attached to the back panel. Use three (3) #8 x 5/8” Pan Head Wood Screws to
secure the rear L-Bracket to cabinet’s back panel. Then, replace the organizer
back onto the slide base, and ensure the top slide mechanism engages with
the rear L-Bracket. Operate the unit to make sure the undermount slides are
working properly.
STEP 5 - Install Front Mounting Bracket
Pull and adjust the front L-Bracket into position onto the side of the face
frame (or cabinet). Allowing for a 3/16” setback. Firmly secure with two (2)
#8 x 5/8” Pan Head Wood Screws. Make sure the gap between the unit and
the side of the face frame is equal from top to bottom. Adjust accordingly
and then securely tighten the bracket set screw (shown with a screw driver).
Operate the unit and make adjustments as necessary for the slides to
operate smoothly.
STEP 6 - Door Installation
B
A
C
Tilt adjustment (up to + 1/4”)
Left/Right adjustment (+/- 7/8”)
Full extension (+2-1/2”)
Up/Down adjustment (+/- 1/4”)
Using a tape measure, determine the mounting location of the top door
mounting brackets. Install door with two (2) #8 X 5/8” Flat Head Phillips
Wood Screws and make necessary adjustments following the diagram
above. To adjust door up or down loosen door mounting screws (A). To
adjust left or right, loosen both set screws (B) adjust and retighten. To adjust
tilt, loosen tilt screw (C), adjust and retighten set screws. Once the door is in
the desired position rmly secure the two bottom door mounting screws.
STEP 7 - Finishing Touches
Unwrap the plastic cutting board and place it into the slot. If the unit came
with canisters, Remove the canisters from its box and place them into their
corresponding circular cutouts.
KBPO 06/20 v1