Installation Sheet

IMPORTANT:

Before you begin, make sure you familiarize yourself with all the

parts and fully read the instructions.

CUSTOMER SERVICE:

Toll-free customer help line available weekdays between

7:00am and 6:00pm Central Time at 800-463-0660.

TOOLS NECESSARY:

Screw gun or Phillips screwdriver and tape measure. NOTE: If

screw gun has a clutch, set to lowest setting so as not to over

tighten and/or strip screws.

PARTS IDENTIFICATION:

A Mounting Base 1 pcs

B Knife Base Pullout Organizer Unit 1 pcs

C Cutting Board 1 pcs

D Canisters (not standard in KBPO-5SC) 3 pcs

E #8 x 5/8” Pan Head Phillips Wood Screw 9 pcs

F #8 x 5/8” Flat Head Phillips Wood Screw 4 pcs

Knife Base

Pullout Organizer

Installation Instructions for

KBPO-5SC/KBPO-8SC

Scan to watch the installation video

http://delivr.com/29x99

STEP 1 - Prepare Organizer for Install

Press

Outward

Press

Inward

Remove the organizer from the slides by pressing the release clip

as shown above.

STEP 2 - Slide Base Installation

Four (4)

#8x5/8”

Pan Head

Phillips

Wood

Screws

Place the slide base inside the cabinet, pulling the front cross member tight

against the rear of the face frame. For frameless cabinets, set the front cross

member back 3/4”. For inset door applications, slide the base back from the

above measurements plus the thickness of the door. Firmly secure with four

(4) # 8 X 5/8” Pan Head Phillips Wood screws provided in the locations shown

above. Replace the organizer onto the slide base. Proceed to the next step.

PAGE 1
Knife Base Pullout Organizer Installation Instructions for KBPO-5SC/KBPO-8SC IMPORTANT: Before you begin, make sure you familiarize yourself with all the parts and fully read the instructions. Scan to watch the installation video http://delivr.com/29x99 STEP 1 - Prepare Organizer for Install CUSTOMER SERVICE: Toll-free customer help line available weekdays between 7:00am and 6:00pm Central Time at 800-463-0660. TOOLS NECESSARY: Screw gun or Phillips screwdriver and tape measure.
PAGE 2
STEP 3 - Mark Rear Mounting Bracket STEP 4 - Install Rear Mounting Bracket 1. Peel off the cover of the double sided tape. 2. Apply inward force 3. Pull organizer slowly outward First, peel off the cover of the double sided tape at the back of the rear L-Bracket. Then applying an inward force at the front L-Bracket to ensure the rear L-Bracket has a firm contact with the cabinet back panel.