Installation & Assembly

STEP 2 - Install Hubs STEP 3 - Shelf Assembly
Insert one Shelf Hub through the bottom of a shelf as shown, making sure the groove in the hub
is opposite of the kidney cut out in the shelf. Place one Shelf Hub Cone on the top of the shelf and
fasten using (3) #8 x 1/2” Flat Head Machine Screws provided. NOTE: Make sure the rib inside the
Shelf Hub Cone is aligned with the groove in the hub (see picture). Repeat with second shelf.
From the top slide one shelf, the other Shelf Support, and then the other shelf onto the Pole
Assembly. Slide bottom of Pole Assembly into the Bottom Mounting Support.
STEP 4 - Pole Extension STEP 5 - Shelf Adjustment
Holding onto the lower pole, twist the upper pole counter-clockwise to release. Extend pole
upwards until it rests rmly against the Top Mounting Support and tighten by turning the upper
pole clockwise.
Raise upper shelf to desired height and tighten the Locking Set Screw. Align the upper shelf kidney
cut-out in its proper position by turning the pole, then raise the lower shelf and tighten the lower
Locking Set Screw.
LSK2 8/16 v.2
Groove
Rib