Installation Sheet

STEP 3 - Install Lower Hub Assembly
Place the Lower Hub Assembly tight against the back corner of the face frame (the
panel divider in frameless applications) and rmly secure with 4 four #8 X 3/4” Pan
Head Phillips Wood screws provided as shown above.
STEP 6 - Install Upper Shelf Assembly
Slide the Upper Shelf Assembly onto the pole. Securely tighten both hub set screws as shown.
STEP 2 -
Determine upper shelf height
2-11/16
DOOR HINGE
KEEPOUT
REGION
13-3/8
MAXIMUM
UPPER
WOOD
TRAY
ADJUSTABLE
HEIGHT
1-3/32
DOOR HINGE
KEEPOUT REGION
13/16
MINIMUM HEIGHT CLEARANCE
ABOVE THE CABINET FLOOR
18-3/16
MAXIMUM
WOOD
TRAY
SYSTEM
HEIGHT
1/4
MINIMUM
POLE
PROTRUSION
Using the diagram as a guide, determine the desired height position of the upper
shelf and make a light pencil market on the side of the face-frame.
STEP 4 - Install Lower Shelf
Assembly
STEP 5 - Install Upper Hub
Assembly
Place one of the Shelf Assemblies on top of the Lower
Hub Assembly and secure in position by sliding the
pole through the center, pushing rmly until the pole is
at the bottom of the cabinet.
Slide the Upper Hub Assembly onto the pole and
position the bottom of the bracket on the line drawn
previously. Firmly secure with ve #8 X 3/4” Flat Head
Phillis Wood screws provided.
HMLS08/17 v.1