Installation Sheet

5. Final Silicone Application
a. Allow time for silicone to dry, following silicone
manufacturer instructions.
b. Once the silicone is dry, apply another bead of silicone
around the outer edge of the bowl where it meets the
vanity top. This will help prevent excess moisture by
creating a seal.
c. Wipe away excess silicone to create a smooth seal.
d. Allow time for additional silicone to dry, following
silicone manufacturer instructions.
6. Attach the assembled top & bowl
to the vanity base
a. Apply a generous bead of silicone around the entire top
edge of the vanity base.
b. Carefully place the top onto the vanity base.
i. The back of the vanity top should be ush with the back
of the vanity.
ii. Situate the vanity top so that there is equal overhang on
each side of the vanity (approximately ½” on either side).
c. Allow time for silicone to dry, following silicone
manufacturer instructions.
d. Move the vanity to it’s nal location against the wall.
7. Install the Backsplash
a. Clean the the underside of the backsplash thoroughly to
remove any debris to ensure a secure hold to the vanity.
b. Apply a generous amount of silicone to the unnished
back of the backsplash.
c. Apply a ¼” bead of silicone to the vanity top where the
backsplash will be placed.
d. Carefully align the backsplash to the vanity top, then rmly
secure in place against the vanity top and wall.
e. Allow time for silicone to dry, following silicone
manufacturer instructions.
f. Once the vanity and backsplash are situated in the nal
location, add, add a nal bead of silicone around the edge
of the backsplash and wall for a secure seal. Smooth the
silicone for a nished look.
8. Install the Sidesplash*
a. Clean the the underside of the sidesplash thoroughly to
ensure a secure hold to the vanity.
b. Apply a generous amount of silicone to the unnished
back of the sidesplash.
c. Apply a ¼” bead of silicone to the vanity top where the
sidesplash will be placed.
d. Carefully align the sideplash to the vanity top, then rmly
secure in place against the vanity top and wall.
e. Allow time for silicone to dry, following silicone
manufacturer instructions.
f. Once sidesplash is situated, add a nal bead of silicone
around the edge of the backsplash and wall for a secure seal.
Smooth the silicone for a nished look.
*Sidesplash is sold separately.
Hardware Resources is not responsible for any error, damage, or injuries from
the installation process as a result of possible printing error in instructions.