Installation Sheet

CAN-EBMSPC-R

Pullout Trash Can System

Included: Tools Needed:Minimum Opening:

Phillips

Screw Driver

Tape

Measure

(optional)

⁄” Screw (x4)

1. Make sure the cabinet hinge will not

interfere with organizer when installed

4. Align front of slide with inside lip of cabinet

5. Screw slide frame into cabinet with 4

included screws

2. Release slide by pushing the black trigger

UP on the LEFT side and DOWN on the

RIGHT side

6. Align and reinsert organizer

into slide frame

3. Remove organizer from slide frame by

pulling forward

7. Push organizer into slide

frame until it CLICKS into place

8. Load trash can into

organizer as shown

Installation Instructions

10-1/4”

Assemble vertical supports:

Insert vertical supports into tubes

on organizer base

PAGE 1
CAN-EBMSPC-R Pullout Trash Can System Installation Instructions Minimum Opening: Included: Tools Needed: 5/8” Screw (x4) Phillips Screw Driver Assemble vertical supports: Insert vertical supports into tubes on organizer base 10-1/4” Tape Measure (optional) 1. Make sure the cabinet hinge will not interfere with organizer when installed 4. Align front of slide with inside lip of cabinet 5. Screw slide frame into cabinet with 4 included screws 2.
PAGE 2
CAN-EBMSPC-R Sistema de bote de basura Système de poubelle à déchets coulissante ESP: Abertura mínima FR: Ouverture minimale ESP: Instrucciones de instalacion FR: Instructions d’installation ESP: Incluido FR: Inclus 5/8” tornillo (x4) Vis de 5/8 po (x4) 10-1/4” ESP: Herramientas necesarias FR: Outils nécessaires ESP: destornillador phillips FR: Tournevis cruciforme (Phillips) ESP: Para montar los soportes verticals: Insertar los soportes verticals en los tubos en la base del organizador.