Installation Sheet

CAN-EBM Series

Pullout Trash Can System

Included: Tools Needed:Minimum Opening:

NOTE:

If using 50qt cans,

cabinet must be

full height (no

drawer).

Phillips

Screw Driver

Tape

Measure

(optional)

⁄” Screw (x4)

1. Make sure the cabinet

hinge will not interfere with

organizer when installed

4. Align front of slide with inside lip of cabinet

5. Screw slide frame into cabinet with 4

included screws

2. Release slide by pushing the

black trigger UP on the LEFT side

and DOWN on the RIGHT side

6. Align and reinsert organizer

into slide frame

3. Remove organizer from slide

frame by pulling forward

7. Push organizer into slide

frame until it CLICKS into place

8. Load trash can(s) into

organizer as shown

Installation Instructions

MINIMUM

OPENING

Assemble vertical supports:

Insert vertical supports into tubes

on organizer base

MINIMUM OPENING

CAN-EBMS 10-1/2”

CAN-EBMD 14-1/2”

CAN-EBMD50 15”

PAGE 1
CAN-EBM Series Pullout Trash Can System Installation Instructions Minimum Opening: Included: Tools Needed: 5/8” Screw (x4) MINIMUM OPENING CAN-EBMS 10-1/2” CAN-EBMD 14-1/2” CAN-EBMD50 Phillips Screw Driver Assemble vertical supports: Insert vertical supports into tubes on organizer base MINIMUM OPENING Tape Measure (optional) 15” NOTE: If using 50qt cans, cabinet must be full height (no drawer). 1. Make sure the cabinet hinge will not interfere with organizer when installed 4.
PAGE 2
CAN-EBM Series ESP: Instrucciones de instalacion Sistema de bote de basura Système de poubelle à déchets FR: Instructions d’installation coulissante ESP: Abertura mínima FR: Ouverture minimale ESP: Incluido FR: Inclus 5/8” tornillo (x4) Vis de 5/8 po (x4) ABERTURA | OUVERTURE CAN-EBMS 26.7cm CAN-EBMD 36.8cm CAN-EBMD50 38.