Installation Sheet

ManualsBrandsHardware Resources ManualsCabinet Hardware8 Inch Base Cabinet Tray Divider Pull Out with Soft-Close Slides

STEP 2 - Mark Rear Mounting Bracket STEP 3 - Install Rear Mounting Bracket

If the countertop is installed, pull the organizer partially open to gain access to the upper slide bracket. Use a

pencil to mark the hole location. Proceed to step 3.

If countertop is not installed, pull the organizer partially out to gain access to the rear bracket and install

three (3) #8 x 5/8” Pan Head Wood Screws provided in the slots. Proceed to step 4.

Remove the unit from the base and slide the rear mounting bracket o the slide. Align the

rear bracket holes with the marks from Step 2 and secure with three (3) #8 x 5/8” Pan Head

Wood Screws in the slots as shown. Re-install the unit onto the slides, making sure that the

top slide is properly seated into the rear mounting bracket. Operate the unit to make sure the

undermount slides are working properly.

STEP 4

Install Pullout Unit

STEP 5

Install Door

STEP 6

Door Mounting Adjustments

Pull the top front mounting bracket into position on the side of the face frame

(or cabinet) allowing for a 3/16” setback (shown left above). Firmly secure with

one (1) # x 5/8” Pan Head Wood Screw. Make sure the gap between the unit

and the side of the face frame is equal from top to bottom. Adjust accordingly

and then securely tighten the bracket set screw (shown right above). Operate

the unit and make adjustments as necessary for the slides to operate smoothly.

Loosen the door mounting set screws and slide bracket out to desired

position to attach to the door rail. Measure from the center of the slot

on the door mounting bracket to the estimated top of door. Mark

door with measurement for both top brackets. Install door with the

four (4) #8 x 5/8 Flat Head Phillips Wood Screws provided. (NOTE:

DETERMINE CORRECT SCREW LENGTH TO DOOR PANEL THICKNESS)

To adjust door up or down loosen door mounting

screws (A). To adjust left or right, loosen both

set screws (B) adjust and retighten. To adjust

tilt, loosen both set screws (B) and then turn tilt

screw (C) clockwise to desired distance and then

retighten set screws.

BPOTD208/19 v.1

Upper slide

3/16” Setback

Bracket set screw

Back of cabinet

Rear mounting bracket

Face frame

Door frame

Center of

mounting

bracket slot

to estimated

top of door

Tilt adjustment (up to + 1/4”)

Left/Right adjustment (+/- 7/8”)

Full extension (+2-1/2”)

Up/Down adjustment (+/- 1/4”)

Door mounting

set screws