Installation Sheet
1 2
3
4
5
1. 3 Components are included in your Drawer Insert Organizer:
A. Base Insert
B. Insert Extension
C. #6 x 3/8β Flat Head Screw
2. Place the Extension (B) in the drawer ξrst toward the right
side of the drawer box.
3. Next, place the Base Insert (A) in the drawer overlapping
the Extension (B).
4. Push the Base Insert (A) to the left drawer box wall while
also pushing the Extension (B) to the right drawer box wall.
5. With the two parts of the insert properly positioned, drive
the #6 x 3/8β Flat Head Screw (C) through the pre-drilled
hole in the Base Insert (A) and into the Extension (B).
Note: Do not overtighten the screw.
DOxx Series Drawer Insert Organizer Installation
800.463.0660 | www.HardwareResources.com
04022021