Installation Sheet
Hole Pattern and Length Specications
DRAWER MEMBER
CABINET MEMBER
Specifications L3 A3 B3 C3 D3
303FUSFT12 -12” 298 96 128 - 88
303FUSFT14 - 14” 348 128 128 - 75
303FUSFT16 - 16” 398 128 192 - 106
303FUSFT18 - 18” 448 160 192 - 94
303FUSFT20 - 20” 498 192 224 - 87
303FUSFT22 - 22” 548 224 224 - 85
303FUSFT24 - 24” 598 192 320 - 142
303FUSFT26 - 26” 648 192 224 160 167
303FUSFT28 - 28” 698 192 256 160 227
Specifications L1 A1 B1
303FUSFT12 -12” 300 94 -
303FUSFT14 - 14” 350 128 -
303FUSFT16 - 16” 400 160 -
303FUSFT18 - 18” 450 224 -
303FUSFT20 - 20” 500 256 -
303FUSFT22 - 22” 550 288 -
303FUSFT24 - 24” 600 352 -
303FUSFT26 - 26” 650 206 224
303FUSFT28 - 28” 700 256 224
1. Cabinet Member Instructions:
Press release clip to disconnect drawer
member from cabinet member.
Align cabinet member (using level if
necessary) and place edge ush with
the edge of the cabinet. Attach to
cabinet using 3 #8 x 7/16” screws. 5
screws can be used for supporting
heavy loads.
2. Drawer Member Installation:
Place front edge of each member
against the rear face of the drawer
front. Screw member with 3 #8 x 7/16”
screws.
3. Drawer Installation:
Align drawer members with cabinet
members and slide into cabinet. When
fully closed, the drawer slide release
clip will lock into place.
• Note:
Face Frame Bracket is optional and
can be used if drawer guide is not
supported in the bottom of the corner
of the cabinet opening.
Installation Instructions
303FUSFT Series
Heavy Duty Slides
Bossier City, LA
www.HardwareResources.com
800.463.0660