Installation Sheet

Frameless Cabinets
Hole pattern drawings
Face Frame
(lip behind door)
Frameless
(no lip)
Install slide in cabinet
1. Separate the cabinet and drawer member of the slide by pressing
the non-handed tripper disconnect release and remove the pull
the two members apart.
! Take note how the slides are oriented which will be necessary
when reassembling the slide.
! The section with the Star shaped hole is the drawer member and
the section with the two sliding pieces is the cabinet member
2. Measure from the top of the cabinet to the desired drawer
location. Draw a level line on the inside of the cabinet where the
top of the cabinet member will mount.
3. Use the line and a level to position the cabinet member to the side
of the cabinet ensuring that the front of the member is ush with
the front of the cabinet.
Install slide to drawer
1. Mount the drawer members to the drawer box sides ush with the
front edge and no more than 1/4” above the bottom edge of the
drawer box.
! Ensure the drawer members are parallel and level for optimal
performance
Install drawer in cabinet
1. Before installing the drawer to the cabinet, ensure that the ball
bearing cage is located to the front of the cabinet member as
shown below. Failure to do so may damage the cabinet member.
2. Carefully insert the drawer members into the cabinet members
and slide the drawer all the way back so that the drawer members
are fully engaged.
3. Cycle the drawer all the way in and back out 4 or 5 times so that
the rear brackets are adjusted.
FRONT
BACK
Flush to ¼” from bottom
DRAWER MEMBER CABINET MEMBER
Specifications L2 A2 B2
303-325-18 - 18” 447 160 212
303-325-20 - 20” 497 192 230
303-325-22 - 22” 547 224 248
all measurements shown in millimeters
Specifications L1 A1 B1 C1
303-325-18 - 18” 450 192 134 326
303-325-20 - 20” 500 224 154 378
303-325-22 - 22” 550 288 138 426
all measurements shown in millimeters
35 64
ø6
4.2
A1 B1 25
L1
C1
L2
9.54.5
4.5
ø4.5
A2 B2