Installation Sheet

Hole Pattern and Length Speciﬁcations

DRAWER MEMBER

CABINET MEMBER

303-300 Series

Heavy Duty Slides

Installation Instructions

1. Cabinet Member Installation:

Press release clip to disconnect

drawer member from cabinet

member. Align cabinet member

(using level if necessary) and place

edge ush with the edge of the

cabinet. Attach to cabinet using 3

#8 x 7/16” screws. 5 screws can be

used for supporting heavy loads.

2. Drawer Member Installation:

Place front edge of each member

against the rear face of the drawer

front. Screw drawer member with 3

#8 x 7/16” screws.

3. Drawer Installation:

Align drawer members with cabinet

members and slide into cabinet.

When fully closed, the drawer slide

release clip will lock into place.

• Note:

Face Frame Bracket is optional and

can be used if drawer guide is not

supported in the bottom corner of

a cabinet opening.

Bossier City, LA

www.HardwareResources.com

Specifications L3 A3 B3 C3 D3

303-300-18-R - 18” 445 160 192 - 94

303-300-20-R - 20” 495 192 224 - 87

303-300-22-R - 22” 548 224 224 - 85

Specifications L1 A1 B1

303-300-18-R - 18” 450 224 -

303-300-20-R - 20” 500 256 -

303-300-22-R - 22” 550 288 -

PAGE 1
303-300 Series Heavy Duty Slides Hole Pattern and Length Specifications DRAWER MEMBER Installation Instructions 1. Cabinet Member Installation: Press release clip to disconnect drawer member from cabinet member. Align cabinet member (using level if necessary) and place edge flush with the edge of the cabinet. Attach to cabinet using 3 #8 x 7/16” screws. 5 screws can be used for supporting heavy loads.
PAGE 2
Serie 303-300 Rieles de trabajo tipo pesado Patrón de agujeros y especificaciones de longitud MIEMBRO DEL CAJON Instrucciones para la instalacion 1. Instalación para el miembro del gabinete: Oprime el clip de liberación para desconectar el miembro del cajón de el miembro del gabinete. Alinee el miembro del gabinete (usando un nivel si es necesario) y coloque el borde a ras con el borde del gabinete. Adjunte el gabinete usando 3 tornillos #8x7/16”. 5 tornillos se pueden usar para soportar cargas pesadas.