Instructions / Assembly

To Install
Verify the size of the water piping thread on which the filter will
be installed.
Adjust the entry and exit of the lower body (part #6) according to
the piping size. If the pipe is 1" (#8) you may connect directly.
If the pipe is 3/4" (#10) you need to use a size adapter (part #9).
You will also need to use the flat seals (#13) when using
the size adaptor.
The thread needs to be covered by a thread sealant for use with
drinking water before making the connection (teflon tape).
Slowly and carefully slide on the two closing rings (part #7)
onto the building's water pipes (#8).
The direction of flow of water should be from the city line
to the building.
Verify the flow direction (#12) of the water in the filter housing (part
#6) according to the arrows stamped on the upper part of the entry
and exit pointing at the direction of the building.
Pay attention!!! Install the inlet pipe on the side with the
valve (#11). The flow is from right to left as seen in the
drawing below.
Screw the pipe on the entry and flush the product by opening the
valve (#11) for 60 seconds.
Flow direction