Instructions / Assembly

PAGE 1
PAGE 2
PAGE 3
PAGE 4
PAGE 5
PAGE 6
ASSEMBLY INSTRUCTIONS NOTE: First Assemble all parts FINGER TIGHT, then eightieth all parts with a wrench when assembly is complete. 1 Vacate and identify all pans. 2. Secure the:Handle (#15) to the top of the: Right Upright Tube (#4) with M8 x Grimm Bolt (#1135 M8 Lock Washer and MB Nut #8). figure 1 3. secure the Handle (#1510 the top ot the Left Upright Tube (#3) with MB x 65mm Bolt MG Lock Washer (#5) and M6 Nut Then screw in the Knobs (#14 } o the bottom of the Handle (#15) figure 4 4.
PAGE 7
8. Place the M8 x 70mm Hex Head Bolts (#1) in'the holes:of the Plastic Block {#2) figure 3 Notelet Bolts: (#1) are hard to push through, you may need a hammer to tap the Boris (#1) through the holes, 9. Lineup the Bolts (#1) and the Plastic Block (#2) with the cone spending holes in the Right and Left Upright Tubes Secure with M6 Lock Washers {#5y and MB Note: For motors over 5HP, iris recommended to install the Plastic Block (#2) on the backside-of the Upright Tubes (33 #4 for greater stability.