Instructions / Assembly

Page 3Rev. 022317
DiscountRamps.com • 1-888-651-3431
Step 2. Slide a main support tube (L) onto each
end of the axle rod (G). The main supports will
only t on the axle rod with the top-end holes
facing outward.
Step 3. Combine the assemblies from Step 1
and Step 2 with two M6x65 bolts (S), lock wash-
ers (V), and nuts (W). The angled support tubes
t inside the main supports, under the axle rod.
(2)
(3a)
(3b)
Step 4. Place a front support tube (K) on each of
the angled supports. Bolt the front support tube
to the main support, then to the handle using the
M8x90 bolts (O), lock washers (P), and nuts (Q).
Do not tighten completely. These bolts allow the
handle to pivot unless the lock knobs are in place.
Step 5. Secure the front support tubes to the
angled supports using two M6x35 bolts (U),
lock washers (V), and nuts (W).
(4)
(6) (7)
(4-5)
Step 6. Attach the engine board (F) to the main
support tubes with four M6x75 bolts (R), lock
washers (V), and nuts (W).
Step 7. Attach a caster wheel to each side of
the completed assembly from Step 6 using two
caster wheels (A), washers (B), and nuts (C).
M8x90
M6x35