GENERAL SAFETY RULES READ’ AND FULLY UNDERSTAND ALL INSTRUCTIONS AND WARNINGS PRIOR TO a USING THIS PRODUCT. YOUR SAFETY 18 MOST IMPORTANT: FAILURE YO. COMPLY WARNING! WITH PROCEDURES AND SAFE GUARDS MAY RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE. REMEMBER! YOUR PERSONAL SAFETY 18 YOUR RESPONSIBILITY Check that all Bolts and Nuts arg tight before saccharine. Lubricate the Wheels periodically: BO NOT OVERLOAD ‘the Motor Carrier.
85 Ib. Capacity Outboard Motor Carrier COMPONENT LIST DIAGRAM PART NUMBER DESCRIPTION ME 70mm carriage bolt (4) Recycled plastic block (1) Left upright tube (1) Right upright tube (1) Lock washer (12) MB nut (12) U-Tube (1) Axle (1) Angled brace supports (04 MB 30mm Bolt (2) M6 80mm Bolt (2) Wheel (2) Wheel locking nut (2) Hand grin (0) Upper spreader bar (1) Alex Washer (4) 12mm Spacer (2) M8 Unlock nut (4) DONE TOOLS REQUIRED 1. Adjustable Wrench 2. Screwdriver 3.
OUTBOARD MOTOR WEIGHT REFERENCE CHART This chart has been created as a reference for determining the weight of vor Outboard Motor. Thewsightbetweena 2-Stroke and 4-Stroke Outboard Motor canary significantly, These weights are only estimates that ais {6 be ties Tor determining what size Outboard Motor Carrier you should purchase: Before placing your Outboard Motor onto the Motor Caviar, t Is highly recommended to refer to the ergs manual you received with your Outboard Motor for the EXACT weight.
ASSEMBLY INSTRUCTIONS NOTE: First Assemble all parts FINGER TIGHT, then eightieth all parts with a wrench when assembly is complete. 1 Vacate and identify all pans. 2: Secure the Upper Spreader Bar #15) tithe Right Upright Tube (#4) with-a M6 x 30mm Bolt M8 Lock Washer (#5) and M6 Nut Repeat this step to attach the Upper Spreader Bar (#15) to the Left Upright Tube #3): figure: 1 3.
8. Place the M8 x Tommie Hex Head Bolts (#1) in the holes of the Plastic Block (2): figure'3 Note: If Bolts hardhat to push through, you may need to use @ hammer to tap the Bolts through the holes. 9: Ling up the Bolts (#1) and the Plastic Block (#2) with the corresponding holes in the Right and Left Upright Tubes (#3, #4): Secure with M6 Lock Washers (#5) and M6 Nuts Note: For introversion § hp, commendation to install the Plastic Block:on the hack side of the Upright-Tubes for greater stability.
