GENERAL SAFETY RULES READ’ AND FULLY UNDERSTAND ALL INSTRUCTIONS AND WARNINGS PRIOR TO a USING THIS PRODUCT. YOUR SAFETY 18 MOST IMPORTANT: FAILURE YO. COMPLY WARNING! WITH PROCEDURES AND SAFE GUARDS MAY RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE. REMEMBER! YOUR PERSONAL SAFETY 18 YOUR RESPONSIBILITY Check that all Bolts and Nuts arg tight before saccharine. Lubricate the Wheels periodically: BO NOT OVERLOAD ‘the Motor Carrier.
130 Ib. Capacity Outboard Motor Carrier COMPONENT LIST DIAGRAM PART NUMBER DESCRIPTION M6 x 70mm Hex Head Bolt(4) Recycled plastic block (1) Right handle tube (1) Left tube (1) MB x 30m Bolt (2) MB x 35mm Bolt (4) MG x 55mm Bolt (B) M6 Nut (18) M8 Lock Washer (18) Vertical Straight Tube (2) Small U-Tube (1) Bolton Straight Tube (2) Large U-Tube (1) Handle Spreader Tube (1) Hand Grip (2) Gas Tank Locking Strap (1) Axle with Alex Brackets (1) Wheel (2) Wheel Shylock Nut (2) DONE TOOLS REQUIRED 1.
OUTBOARD MOTOR WEIGHT REFERENCE CHART This chart has been created as a reference for determining the weight of vor Outboard Motor. Thewsightbetweena 2-Stroke and 4-Stroke Outboard Motor canary significantly, These weights are only estimates that ais {6 be ties Tor determining what size Outboard Motor Carrier you should purchase: Before placing your Outboard Motor onto the Motor Caviar, t Is highly recommended to refer to the ergs manual you received with your Outboard Motor for the EXACT weight.
ASSEMBLY INSTRUCTIONS NOTE: First Assemble all parts FINGER TIGHT, then eightieth all parts with a wrench when assembly is complete. 1 Vacate and identify all pans. 2. Attach Bottom Straight Tubes (#12) tithe Alex Brackets Secure together using MB:x 38mm:Bolls ME Lock washers (#9) and M8 Nuts figure 1 3.
6: Install the Handle Spreader Tube onto the connections on both the Right and Left Handle Tube sing MB x 30mm Bolts, M6 Lock Washers; and M8 Nuts. figure 5 figure 5 figure 5 7.
