Instructions / Assembly

Page 1Rev. 073018

DiscountRamps.com • 1-888-651-3431

Boat Boarding Ladders

Instructions for Part # Boarding-Ladder

Unfold the top arms and stopper

legs. Hook the top arms over

the side of your boat, resting the

stopper legs against the side of

the boat to stabilize the ladder.

Fold in the top arms

and stopper legs for

convenient storage.

Tools Needed: Phillips-Head Screwdriver, 11mm Wrench

The stopper legs may be attached to any step appropriate for your boat.

1. Locate the mounting holes in the step. There are two holes on each side of each step.

2. Attach each stopper leg so that it will sit straight out when extended and can be folded down to-

wards the center of the step. Use a Phillips screwdriver and an 11mm wrench to bolt it into place.

Assembly

Use

3. The stopper leg has two settings to adjust the length. To adjust the length, remove the bolt in the

middle of the leg, slide the leg to the appropriate setting, then replace and tighten the bolt.

(1) (2a) (2b)

(3a)

(3b)

stopper leg

PAGE 1
Boat Boarding Ladders Instructions for Part # Boarding-Ladder Assembly Tools Needed: Phillips-Head Screwdriver, 11mm Wrench The stopper legs may be attached to any step appropriate for your boat. 1. Locate the mounting holes in the step. There are two holes on each side of each step. 2. Attach each stopper leg so that it will sit straight out when extended and can be folded down towards the center of the step. Use a Phillips screwdriver and an 11mm wrench to bolt it into place.
PAGE 2
General Guidelines • It is the user’s responsibility to read and follow all instructions. • Keep these instructions with the product at all times and review before each use. • It is the responsibility of this product’s owner to furnish the instructions to any person that borrows or purchases the product. • Inspect the product before use to ensure it is assembled properly and all parts are in safe working order and free of defects. • Never modify this product in any way.