Product manual

Page 6 For technical questions, please call 1-888-866-5797. Item 93068
Operation
Power Switch
The Power Switch has three settings:
a. Off: Power is off.
b. Hi: A loud beep will sound
(approximately 92dB) and the LED
will flash when motion is detected.
c. Low: A short beep will sound
(approximately 80dB) and the LED
will flash when motion is detected.
Operation
1. To operate the Driveway Alert, slide
the Power Switch on the Receiver
to the “Hi” setting. Allow 30 seconds
for warm-up. Two short beeps will
sound, indicating the unit is working.
2. Test the Sensor by walking or
driving into the protected area.
Another person should be listening
for the alarm to sound.
3. If the Sensor does not activate,
Sensor relocation or aiming
adjustment will be required.
4. If the Receiver does not activate with the
Sensor, reposition them closer together.
5. Once you have determined that the unit
is working properly, leave in the “Hi”
setting or adjust to the “Low” setting.
Low Battery
1. Replace the Sensor batteries when
the LED on the Sensor turns on.
2. Replace the Receiver batteries when
the LED on the Receiver turns on.