Product manual

Page 5For technical questions, please call 1-888-866-5797.Item 93068
Setup Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
Installing Batteries
CAUTION: Position batteries in
proper polarity and do not install
batteries of different types, charge
levels, or capacities together.
1. Using a screwdriver (not included),
remove the Battery Cover of the
Sensor, and insert a 9V battery (not
included). Replace the Battery Cover.
2. Using a screwdriver (not included),
remove the Battery Cover of the
Receiver, and insert three
C batteries (not included).
Replace the Battery Cover.
Note: An optional 6 volt, 200 mA power
adapter (not included) can be used to
power the Receiver instead of batteries.
Installing the Sensor and Receiver
CAUTION: Verify that installation
surface has no hidden utility lines
before drilling or driving screws.
1. Consider the following when
choosing a location for the Sensor:
a. The passive infrared sensor detects
heat. Avoid aiming it towards
areas that produce heat such as
heater vents, windows where the
sun hits, or outdoor spotlights.
b. Mount the Sensor at least 3
feet above the ground. If placed
under the garage eaves, be sure
that the Sensor is not blocked
by the roof facia board.
c. If placed above 8 feet high,
the Sensor should be aimed
downward so that it is pointed
toward the area being monitored.
2. Mount the Sensor to a flat
surface with hardware (3).
3. Place the Receiver within
400 feet of the Sensor.
Note: Obstructions may reduce
the receiving range.
4. Mount the Receiver to a flat surface
with hardware, or stand on a
flat surface. The receiver is not
intended to be weather resistant.
Note: Do not install the Receiver
in a location that will get wet or
directly exposed to the elements.