Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 69805
13. Position a Top Short Brace (3)
with each of its ends aligned
with the Top Long Braces.
14. Insert four Carriage Bolts through the
aligned mounting holes of the two
Legs and Top Short Brace. Attach
Spring Washers and Nuts to the
Carriage Bolts and loosely tighten.
Top Short
Brace (3)
Bottom Long
Brace (2)
Bottom Short
Brace (5)
Top Long
Brace (1)
Leg (4)
Nut (8)
Spring
Washer
(9)
Carriage
Bolt (7)
Figure 5
15. Repeat Steps #13 and #14 above
to attach the remaining Top Short
Brace to the remaining two Legs.
16. Place the Tool Stand at the location
where it will used. With the aid of
a corner square and a level, make
sure the top of the Tool Stand is level.
Then, wrench tighten all of the Nuts.
17. Install tool to the top of the stand,
bolting it in place in at least 4 places.
NOTE: A plywood top (not included)
may be needed as an adapter to mount
some tools. The diagram that follows
shows approximate dimensions. Also,
some tools may require a hole cut in the
plywood to allow proper ventilation or
sawdust removal — see tool instructions.
Figure 6
3/8" DIA.
HOLE
18-3/4"
13/16"
20-7/8"
4-7/32"
5/8" OR 3/4" THICK PLYWOOD
7/8"
3-1/8"