Product manual

Page 4 For technical questions, please call 1-800-444-3353. Item 69805
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
Note: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram near the end of this manual.
Assembling Tool Stand
1. Position the four Extension
Feet (6) on the bottom, outside
edges of the four Legs (4).
2. The height of the Tool Stand may
be adjusted to either 26, 29, or 32
inches. Slide the Extension Feet up
or down along the bottom, outside
edges of the Legs until the desired
height of the Tool Stand is reached.
Adjust the Feet to equal length.
Figure 1
Leg (4)
Extension
Foot
(6)
Carriage
Bolt (7)
Nut (8)
Spring Washer
(9)
3. Insert four Carriage Bolts (7) through
the four mounting holes in each
Extension Foot and Leg. Attach Spring
Washers (9), and Nuts (8) to the
Carriage Bolts and loosely tighten.
4. Align the mounting hole located at
each end of a Bottom Long Brace (2)
with a mounting hole located on the
lower, inside edges of two Legs.
Leg (4)
Bottom Long
Brace (2)
Nut (8)
Spring
Washer
(9)
Carriage
Bolt (7)
Figure 2
5. Insert two Carriage Bolts through the
aligned mounting holes of the Bottom
Long Brace and two Legs. Attach
Spring Washers and Nuts to the
Carriage Bolts and loosely tighten.
6. Repeat Steps #4 and #5 above to
attach the remaining Bottom Long
Brace to the two remaining Legs.