Product manual

Page 7For technical questions, please call 1-888-866-5797.Item 96755
SAFETYOPERATIONMAINTENANCE SETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram near the end of this manual�
1� Push the End Clip forward and down to
release the Staple Channel Latch� Pull
out the Staple Channel� See figure A�
2� Load the staples or brad nails into the
Staple Channel� Each of the fasteners
is to be loaded into the Staple Channel
with its sharp end facing the base of
the Staple Channel� See figure B�
3� Staples are to be inserted into the center of
the Staple Channel as shown in figure B�
Brad nails are to be inserted on either side
of the Staple Channel, as in figure B, but not
placed in the center of the Staple Channel�
4� To adjust force that will be exerted on the
fastener to drive it deeper into the work piece,
use the Depth Adjustment Knob located at
the top of the Staple Gun� See Figure A�
5� Turn the Depth Adjustment Knob
clockwise to increase the force to drive
the fastener, and counterclockwise
for less force driving the fastener�
Push in and down to
release the Staple
Channel Latch�
Figure B
Standard
staple
U-Shaped
staple
Brad
Figure C
Workpiece and Work Area Set Up
1� Designate a work area that is clean
and well-lit� The work area must not
allow access by children or pets to
prevent distraction and injury�
2� Secure loose workpieces using a
vise or clamps (not included) to
prevent movement while working�
3� There must not be objects, such
as utility lines, nearby that will
present a hazard while working�