Product manual

Page 11For technical questions, please call 1-800-444-3353.Item 61433
Pulling Out the Dent
1. Slip the head of the Slide Hammer over the
welded stud and tighten it on the exposed tip of
the stud by holding the Back Handle and turning
the Head Roller away from the workpiece.
2. With one hand on the Center Handle and
one on the Back Handle, apply a backward
hammering motion, hammering the Center
Handle against the Back Handle (away from
the workpiece) until the dent has popped out.
CAUTION! Keep hands clear of pinch points.
3. To disengage the Slide Hammer head from the
stud, gently tap the Center Handle forward against
the head of the Hammer until the stud is released.
4. Cut the stud off and grind it down so it
is flush with the metal surface.
Back HandleCenter Handle
Workpiece
Stud Hammer Head
Head Roller
Figure D
SAFETYOPERATIONMAINTENANCE SETUP