Specifications Light Bulb White LED Battery Type AAA NiCd Charge Time 6 hr. Running Time 9 hr. Solar Cells Amorphous Silicon Important Safety Information 1. Assemble only according to these instructions. Improper assembly can create hazards. 2. Wear ANSI-approved safety goggles during setup. 3. Keep assembly area clean and well lit. 4. Keep bystanders out of the area during assembly. 5. Do not assemble when tired or when under the influence of drugs or medication. 6.
Setup Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual. Battery Setup There may be a paper tab in one end of the battery between the Battery (5) and the electrical contact so the Battery won’t drain over time. To remove this: 1.
Operating Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product. Tool Set Up 1. Decide where you want to place the Solar Light Set. Choose a location that receives full, direct sunlight a minimum of eight hours a day. The location should not be near nighttime light sources such as porch lights or streetlights as this will cause the Solar Light Set to remain off.
Maintenance Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use. 1. Clean regularly with a damp towel. 4. Replace the batteries every 12 months. Do not use any type of solvent for a. Twist the Lamp Housing cleaning.
Troubleshooting Problem Light will not turn on Possible Causes Probable Solutions 1. Auto/Off Switch not set to “Auto”. 1. Check position of Auto/Off Switch. 2. Battery not allowed time for recharging via Solar Panel. 2. Check that Solar Panel has direct access to sunlight. Allow one to two days for a full charge. 3. Solar Light is set near nighttime light sources such as porch lights or street lights. 3. Move Solar Light or change Solar Panel position. 4.
Parts List and Diagram Part 1 2 3 Description Lamp Housing Lamp Cover Pole 4 Qty Part 10 10 10 4 5 Description Qty Stake NiCd AAA Battery 3 2 10 10 1 5 Record Serial Number Here: Note: If product has no serial number, record month and year of purchase instead. Note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. Item 69461 For technical questions, please call 1-800-444-3353.
Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.
