Product manual

Page 6 For technical questions, please call 1-800-444-3353. Item 60618
SAFETY OPERATION MAINTENANCESETUP
Initial Tool Set Up/Installation
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Note: This air tool is shipped with a protective plug covering the inlet. Remove this plug before set up.
Installation
Note: Abrasive Blaster required for
operation, sold separately.
1. Close air supply valve, disconnect air supply
from Abrasive Blaster, and release all pressure
from its Tank by pulling the safety valve.
2. Empty all abrasive media from the
Abrasive Blaster and its hoses.
Note: Any remaining abrasive media
may cause clogging and/or undesirable results.
3. Disconnect the Abrasive Valve Assembly’s three
connections as listed below and shown in Figure A:
a. Air Hose Connection
b. Tank Connection
c. Abrasive Hose Connection
Air Hose
Connection
Abrasive
Hose
Connection
Abrasive
Valve Asm.
Tank
Connection
Figure A: Disconnect Three Abrasive Valve Asm.
Connections
(Item 68994 shown for reference.)
4. Clean disconnected hose ends and
threads leading into the tank. Remove all thread seal
tape from threads and chase threads if needed.
5. Remove the Cover (1) from
the top of the Service Tee (2).
6. Wrap the threads on the top of
the Service Tee (2) with at least three wraps
of thread seal tape (sold separately).
7. Thread the Service Tee (2) into the bottom of the Tank
by hand as far as possible, then wrench tighten it.
8. The Hose Barb Fitting (8) that is angled upward
is used to attach a plain Air Hose. Secure this
connection using a Hose Clamp (sold separately).
Note: For an Air Hose with a threaded fitting:
a. Unthread and remove the Hose Barb Fitting (8).
b. Wrap the threads on the end of
the Air Hose with at least three wraps of
thread seal tape (sold separately).
c. Thread the Air Hose into the 45° Elbow (9)
by hand as far as possible, then wrench tighten it.
9. Slip the Abrasive Hose over the Hose Barb Fitting (8),
and secure it with a Hose Clamp (sold separately).
10. Wrap the threads on the end of
the Purge Hose (10) with at least three wraps
of thread seal tape (sold separately).
11. Thread the Purge Hose (10) into the Ball Valve (5)
by hand as far as possible, then wrench tighten it.
Air Hose
Connection
Abrasive
Hose
Connection
Soda
Blast
Asm.
Purge
Hose (10)
Tank
Connection
Figure B: Kit Installation