Product manual

SKU 91495 For technical questions, please call 1-800-444-3353. Page 3
Slide both Axles (7) into the Frame (1). Slide the Wheel (9) (be sure the valve stem is facing 3.
out) and then a Large Washer (10) onto the Axle. Thread a Nylon Axle Nut (8) onto the end
of the axle and tighten, leaving enough space to permit the wheel to turn freely. Repeat for
all Wheels. See Figures A & B.
Be sure the Adjustment Lever (18) is screwed onto Seat Post (6). The Seat (5) is attached 4.
to the Seat Post (6) with four Tapered Bolts (16) and Flange Nuts (17). Twist Seat (5) and
Seat Post (6) assembly into the Frame (1) clockwise. The threaded Post needs to be seen
from below the Frame. Insert the Cotter Pin (11) through hole in the Post. Spread open the
Cotter Pin (11). See Figures C & D.
Assembly Instructions
Assemble all parts on a smooth surface to avoid scratching. Sort and identify all parts. 1.
Additional tools will be necessary to assemble the Rolling Work Seat. (Tools not included).
Matching up all the predrilled holes, attach the Tray Bracket (2) to the Frame (1), the Plastic 2.
Tray (4) and the Reinforcing Plate (3) using the Screws (14), Small Washers (11), Lock
Washers (12), and Small Nuts (15). Tighten hardware. See Assembly Drawing, page 4.
Loosen Adjustment Lever (18) to set the desired height. Adjust Seat height by rotating the 5.
Seat in the Frame. Rotate Adjustment Lever (18) to lock seat post in position. The Adjustment
Lever (18) will prevent the Seat from lowering beyond the desired height. Before each
use, check the Seat (5) to make sure that the Seat is securely in place with all hardware
tightened down. Caution: Do not use the Rolling Work Seat on inclines. Do not load
Tray (4) with more than 5 lbs. Maximum weight for Seat (5) is 300 lbs. This product is
not for use by children.
Figure C
Figure D
Seat (5)
Tapered
Bolt (16)
Flange
Nut (17)
Seat Post
(6)
Frame (1)
Figure A
Valve
Stem
Wheel
(9)
Large
Washer
(10)
Nylon Axle
Nut (8)
Figure B
Tray (4)
Axle
(7)
Adjustment
Lever (18)
REV 06e; 09f