Product manual

Page 14 For technical questions, please call 1-888-866-5797. Item 65818
SAFETY WELDING CUTTING MAINTENANCESETUP
Cutting
Cutting Tip Pressure Settings
The Cutting Attachment is used to cut metal up to 3″ thick.
The included tip, size 0, cuts metal up to 1/2″ thick.
Check the thickness of the metal to be cut and use the chart below to choose the appropriate size tip for the job.
If cutting metals over 1/2″ thick, a different tip will be needed.
Table B: Cutting Tip Flow Data
Cutting
Thickness
(inches)
Standard
Nozzle
Size
Cutting Oxygen
Pressure
(PSIG)
Acetylene
Pressure
(PSIG)
Speed
(IPM)
1/2 0 30~35 3~5 20~24
3/4 1 30~35 3~5 17~21
1-1/2 2 40~45 3~7 13~17
2-1/2 3 45~50 4~10 10~13
3 4 45~50 5~10 9~12
The Cutting Attachment is attached to the Torch Handle and a Cutting Tip
is attached to the end of the Cutting Attachment.
Pre-heat Oxygen Valve: Adjusts pre-heat flame oxygen level.
Oxygen Cutting Lever: Activates extra flow of oxygen for cutting.
Cutting Attachment (5)
Torch
Handle (7)
Cutting
Tip (6)
Oxygen
Cutting
Lever
Pre-heat
Oxygen Valve
Acetylene (GAS)
Torch Valve
Oxygen (OXY)
Torch Valve