Product manual

Page 5For technical questions, please call 1-800-444-3353.Item 66433
Set Up Instructions
Read the ENTIRE IMPORTANT SAFETY INSTRUCTIONS section at the beginning of this
manual, including all text under subheadings therein before setup or use of this product.
Risk of accidental starting, resulting in serious personal injury. Turn the Power Switch of the Light
OFF and unplug it from the electrical outlet before assembling or making any adjustments.
Deviation from the assembly instructions may result in a risk of re or electric shock.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Setup
1. Slide the Bracket (13) over the Lower
Grip (14), lining the hole in the Bracket
up with the bolt hole in the Grip.
2. Insert the Knob (20) through the Concave
Washer (34) and into the hole.
3. Remove the Bolt (38) at the top of the
housing and open the Lamp Cover (24).
4. Insert the Bulb (27) into the Bulb Socket (18).
Caution: Do not touch the Bulb with your bare
hands; oil from skin will drastically shorten the life
span of the bulb if not cleaned with rubbing alcohol
and allowed to dry before use. Handle the bulb with
a soft, clean cloth or clean work gloves instead.
5. Close the Lamp Cover (24) and
secure with the Bolt (38).
6. Gently squeeze the Wire Cover (25) while
placing its four tabs into the Lamp Cover (24).
Secure the tab on the Wire Cover to the Lamp
Cover using the Screw (39). (See Figure A.)
Figure A
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INSTRUCTIONS section at the beginning of this
manual, including all text under subheadings therein before setup or use of this product.
1. Plug the Light into a standard 120V
grounded, electric outlet.
2. Push the On/Off switch on the back of the light.
3. WARNING! Keep the Light away from
combustible objects. The light and housing
will get hot enough to start a re.
4. To turn off, push the On/Off switch.
5. To prevent accidents; turn off lights
and disconnect power supply after use.
Allow the Lights to cool. Clean, then store
the Light indoors out of children’s reach.